加工条件・トラブルシュート | オーエスジー

Showing 1-7 of 7 results

answer

 Can grooving be done with multiple flutes end mills?

A typical four-blade end mill is not recommended for grooving where chip pockets are narrow and a large amount of chips need to be ejected.

The two-blade end mill has a wide chip pocket and good chip discharge, so it is effec

No : 686
Published : Modified : 2024/08/28 02:29
answer

How much cutting data should be adjusted depending on the flute length and overhang length of the end mill?

The longer the amount of protrusion relative to the diameter of the tool, the more vibration and deflection will occur during machining. By lowering the conditions, it is possible to reduce the force that caus

No : 691
Published : Modified : 2024/08/28 02:29
answer

Cutting data of long blades

The EDL cutting data table is not listed in the catalog, but the feed and rotation are adjusted according to the amount of protrusion based on the cutting data of the general end mill EDS.

References: Overhang and cutting data

[Side cutt
No : 694
Published : Modified : 2024/08/28 02:29
answer
What is helical machining?

Helical machining refers to processing that uses planetary motion by the X, Y, and Z three-axis simultaneous control function.

On the mechanical and equipment side, a helical interpolation function is required.

Even with small machining centers and workpiece geometries with poor rigidity, the machining load can be adjusted,

No : 901
Published : Modified : 2024/08/28 02:29
answer
How to calculate cutting conditions during helical machining Rotation speed, feed rate, distance traveled in the Z-axis direction per helical lap

Learn how to calculate cutting data for helical machining on end mills and indexable ( chip exchangeable) cutters.

As an example, let's consider the case of helical machining of a φ18 hole

No : 10419
Published : Modified : 2024/08/28 02:29
answer

What are the effective measures against vibration?

The causes and countermeasures for trembling are summarized below.

Please refer to it if you like.
 
No : 13940
Published : 2024/10/22 00:00 Modified : 2024/11/04 14:49
answer
Resin processing_Is there a cutting data reference table for end mills and cutters?

Resin processing_Is there a cutting data reference table for end mills and cutters?

Our non-ferrous DLC end mills (AE-TS-N, AE-TL-N, AE-VTS-N, PXAL) can also be used for resin processing.

The types of resins listed in the
No : 14329
Published : 2024/10/22 00:00 Modified : 2024/11/01 02:38

Searching in progress