ado-sus ステップ加工 | オーエスジー

ADO-SUS Step Machining

When processing SUS in the ADO-SUS series, it is basically recommended to use a non-step.

This is because step processing increases the opportunity to rub the inside of the hole, resulting in work hardening.

The strain on the blade by the step causes a decrease in the service life.

If the chips are difficult to divide and discharge, check the situation with a step (pick feed) of about 1 times the drill diameter.

For heat-resistant alloys such as Inconel 718, step processing should be performed according to the situation when exceeding 3D.

References: ADO-SUS Series