戻る
The new normal of three-blade drills! What is ADO-TRS?
I want to improve my drilling process.
I hear that a three-blade drill is more difficult to use than a two-blade drill, but if you are looking for a good drill.
There is ADO-TRS.
For the difference between a three-blade drill and a two-blade drill, please refer to the link below.
What is the difference between a three-blade drill and a two-blade drill?
In general, three-blade drills are difficult to use for the following two reasons.
- High thrust resistance.
・ By increasing the number of flutes , the chip pocket becomes narrower and it is difficult to drain chips.
These may interfere with the original purpose of "improving efficiency" and "improving hole quality".
The higher the efficiency, the higher the cutting force and the more chip evacuation is required.
ADO-TRS is a drill that reduces the disadvantages of 3-blade blades and provides many advantages.
Features of ADO-TRS that overcome the disadvantages of 3-blade blades
(1) R-Gash (PAT.P)
・Low thrust resistance comparable to 2 blades!
・Produces fine and stable chips!
(2) Wide chip pocket
・Drain chips smoothly!
(3) EgiAsscoating
・Overwhelmingly high durability + high chip discharge by groove smoothing
With these specifications, you can expect to get the following benefits.
・ Possibility of increasing efficiency compared to two-blade drills
Depending on the required accuracy, it may be possible to omit the finishing process after drilling holes with a two-blade drill.
・Possibility of increasing the life of tools such as Tap and reamers by stabilizing the replacement of the post-process
ADO-TRS offers these benefits in more situations than conventional tools.
It is no longer difficult to use a three-blade drill.
The new common sense of three-bladed blades! Please consider ADO-TRS.
(FAQID:5429)