戻る
This is a method of machining by sending the tool in the axial direction.
If you have a drill or a center-cut end mill (with a blade that extends to the center of the end cutting edge ), you can perform hole drilling.
When thrusting with an end mill, it is recommended to use two blades because chip discharge is required.
( If the number of flutes is small, the chip pocket is wide and the chip discharge is rich)
If you want to perform horizontal pulling after thrusting, please consider the following special tools.
• WX-Coated 3-Blade Slotting Stub End Mill WX-SHTSS
It is a three-blade end mill that achieves both chip discharge and efficiency.
There is also a cutting condition table for side processing, grooving, and piercing processing.
・ Multi-function cutter series PMD
It is an indexable cutter that can be used for various processes.
The bottom can be flattened with plunging , and it can also be pulled horizontally as it is.