戻る
< Band Saw > Processing Trouble Blade chipping Causes and Countermeasures
| (1) Excessive descent speed | Adjust the scale to achieve the correct descent speed |
| (2) Inadequate function of the wire brush | Overwear is replaced, and if the position is not suitable, adjust it. |
| (3) Less cutting oil | Increase the amount of cutting oil and adjust the nozzle to the proper position |
| (4) Under-sized saw blade pitch | Increase the saw blade pitch or reduce the descent speed |
| (5) The square timber begins to cut, and the blade hits the corner. | Reduce the saw blade pitch, tilt the workpiece or reduce the descent speed |
| (6) The cutting length increases rapidly at the end of the cutting of square timber and columns. | Increase the saw blade pitch and reduce the descent speed |
| (7) The vertical runout of the saw blade is large. | Check and adjust the uneven wear of the idling drum, loose guide arm, and saw blade core. |
| (8) Insufficient leveling operation | Perform sufficient smoothing |
| (9) The guide width is too wide | Adjust the width to be suitable for the workpiece width |
| (10) Low clamping force | Cleaning the vise surface, checking the oil pressure, changing the hydraulic fluid |
| (11) Hit Backup Guide | It's too far away... adjust |
| (12) Low tension | Adjust to the appropriate value |